Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateStyles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
See the difference
Before
After
Before
After
Before
AfterHow Much Does Gate Repair Cost in Folsom?
Gate repair in Folsom typically runs $150 to $950, with most single-issue repairs landing between $250 and $450. A gate stuck open, dragging on its track, or refusing to respond to a remote is usually a same-day fix. Full operator replacement or control-board work pushes the number higher, but you’ll know before we start; the written estimate sets the final price.
We’re Gate Repair Folsom, and gates are the only thing we touch. That matters in a town where half the properties on a street have a different brand of operator. We’re factory-familiar with nine of them – LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule – so we walk up to your gate already speaking its language. For a deeper look at what we do, see Gate Repair Folsom.
Key Takeaways
- Most residential gate repairs in Folsom cost $150 to $950, depending on the part and the operator.
- Electric gate and control-board problems sit at the higher end because the diagnostic work is real.
- Free estimates by phone or on-site; the written estimate is the final price.
- Same-day service is common. Call (833) 593-3926. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
- If a repair turns out to be a replacement, we handle the new installation too – same team, no second company.
Gate Repair Cost Breakdown (2026)
Here’s how the numbers break down for Folsom jobs. These are typical ranges, not quotes – the written estimate after we see your gate sets the actual price.
| Repair or service | Typical range |
|---|---|
| Service call, inspection, and adjustment | $150 – $250 |
| Hinge, roller, or hardware repair | $150 – $350 |
| Swing-arm or slide operator repair | $300 – $650 |
| Control board or receiver replacement | $350 – $750 |
| Remote and keypad replacement | $150 – $300 |
| Safety sensor or loop detector repair | $250 – $550 |
| Actuator or motor replacement (residential) | $450 – $900 |
| Full operator replacement (residential) | $950 – $2,500 |
| Commercial operator or high-cycle system repair | $500 – $1,800 |
What pushes a job toward the top of a range? The brand and the model, mostly. A Ghost Controls or Mighty Mule residential opener is straightforward to source parts for, so repairs stay modest. A DoorKing setup on a commercial entry, or a FAAC or BFT system running high cycles, takes more diagnostic time and heavier components. Add in whether the gate is a swing or a slide, whether the problem is mechanical or electrical, and whether the operator housing is easily accessible. A crusty gate on a rural lot is faster to fix than one bolted into a masonry column with the wiring buried in conduit.
One thing we’d flag. An electric gate is wired to line power and one of its panels can weigh more than a grown adult. Those are the two hazards that send people to the emergency room. We advise against opening the operator box or wrestling a heavy panel yourself; a trained technician should do that work. If your gate is stuck, we’re glad to take a look. Schedule a gate repair visit and we’ll tell you exactly what’s wrong.
What Affects Gate Repair Pricing in Folsom
Folsom sits in the Sacramento Valley foothills, warm and dry most of the year with wet winters. That climate shapes how these gates fail, and that shapes the price.
- Dust and dry heat. From spring through fall the local climate is dusty. Dust and grit collect in slide-gate tracks and work their way into the rollers and hinges. That’s the most common reason a Folsom gate starts dragging or slowing down before anything electronic fails.
- Winter rain. Wet winters work silt and small debris into the same tracks and around the operator housing. We see a stack of track-clearing and adjustment jobs after rain, because a gate that was only slightly stiff in summer stops traveling cleanly once it’s wet.
- Brand and model. Parts pricing and availability vary a lot from brand to brand. Linear, LiftMaster, and Elite parts are quick to source. Ghost Controls and Mighty Mule tend to be economical homeowner systems. FAAC, BFT, and DoorKing sit in the professional and commercial grade, so parts and labor reflect that.
- Mechanical vs. electrical. A hinge or roller is a hardware fix. A control board, keypad, or loop detector adds diagnostic time and electronic diagnosis. That’s exactly the work most general handymen avoid, which is why we name electric gate repair as a core service.
- Swing vs. slide. Slide gates have a track that can bind. Swing gates stress their hinges and arms. The failure mode is different, and the labor follows.
- Access and layout. Whether the operator is reachable, how clean the wiring run is, and whether your gate is on a hilltop lot or a tight side yard all affect how long the job takes.
How to Save on Gate Repair
A few things go a long way toward keeping the bill down.
- Call when it’s slow, not stuck. A gate that drags or binds is a cheaper fix than one that’s seized or dead. Catching it early keeps the problem in the lower half of the range.
- Clear the track. In this dry climate, a quick sweep of the slide-gate track keeps grit out of the rollers. That’s maintenance, not repair, and it costs nothing.
- Get the free estimate first. There’s no fee to have us look, and no obligation. The estimate comes as a written price before we turn a wrench.
- Know the brand. If you can tell us the operator brand up front, we can often bring or source the right part faster. Recognition saves billable diagnostic time.
- Consider repair before replacement. A new operator can be the right call, but only if the existing one is actually finished. We’ll give you a straight answer either way, and if a replacement makes sense, we can install it – so you’re not starting over with a different company.
FAQs – Gate Repair Cost
How much does gate repair cost in Folsom?
Most Folsom gate repairs cost between $150 and $950, with a typical single-issue fix around $250 to $450. Control-board work, actuator swaps, and full operator replacements land at the top of that range. Call (833) 593-3926 for an exact quote; estimates are free.
Is it cheaper to repair or replace a gate operator?
Repair is usually cheaper, at $300 to $900, versus $950 to $2,500 for a new residential operator. Replacement only wins when the board and the motor are both failing, or parts are no longer available. We’ll tell you which side of that line your gate is on. Call (833) 593-3926 to book a look.
Can you fix my electric gate the same day?
Often, yes. Same-day service is common for single-issue repairs because the nine brands we work on are in our diagnostic wheelhouse. Fast dispatch from 7am to 7pm, Sunday through Friday. Call (833) 593-3926. We answer 24/7, and a call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm.
Do you charge for an estimate?
No, the estimate is free. The price is set per job by the written estimate, so what you see is what you pay. Call (833) 593-3926 to schedule.
What does a control-board or sensor repair cost in Folsom?
Control-board and receiver replacement typically runs $350 to $750, and safety sensors or loop detectors run $250 to $550. Wiring, power, and diagnostics on an automated gate are the parts most general repair companies won’t touch, but they’re our core work. Call (833) 593-3926 for a free quote.
Why Choose a Gate-Only Specialist
Gate Repair Folsom is a single-trade shop. Every tool, every part, and every trained hour is spent on gates. No fence panels, no garage doors, no general contracting. That single focus is why we recognize your brand on sight, why we carry compatible parts, and why we don’t burn the first hour figuring out your system.
We’ve been serving Folsom since 2014. That’s 12 years of working on residential and commercial gates across the valley – LiftMaster and Linear on the homeowner side, Ghost Controls and Mighty Mule for entry-level automation, and FAAC, BFT, and DoorKing where property managers need durable, high-cycle systems. If a repair turns into a replacement, we handle the new installation too, from the operator to the gate itself.
For a full rundown of our services, visit Gate Repair Folsom.
Ready to Get Your Gate Fixed?
Whether your gate is stuck open, dragging on the track, or the keypad has gone dark, we can tell you what’s wrong and what it costs before we start. Estimates are free, same-day service is common, and we work on your brand – from a residential Mighty Mule to a commercial DoorKing. Call (833) 593-3926. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Pricing reflects the Folsom market as of 2026. Gate Repair Folsom offers free estimates – call (833) 593-3926.
Written by the team at Gate Repair Folsom, serving Folsom since 2014.
What Our Customers Say
"The loop detector under the driveway had failed and residents were stuck holding the button. He traced it, found the break, and had the exit loop reading cars again the same visit."
- David Wong"Solar panel on our remote gate wasn't keeping the battery up through the winter. He repositioned it, replaced the battery, and explained the math on why the old placement was never going to work."
- Adam Miller"Gate stopped halfway and sat there for two days blocking the driveway. He found a dead capacitor in the operator, had one with him, and we were moving cars again in under an hour."
- Brandon Lin